Resources
Vehicle verification & measurements
We keep measurements on file for most truck makes and models. Depending on your make, model, bed length, and generation, we may already have what we need. If we do not, we will ask you for a few quick measurements. This guide covers what to measure and how, for both camper platforms.
Interactive guide
See every measurement in 3D
Turn the truck to see where each measurement starts and ends. Pick a letter to zoom in on it.
Loading the truck…
Drag to turn · Scroll or pinch to zoom
Caps and covers
Have a cap or tonneau cover on your truck?
You can usually still get the measurements that matter most. Measure what you can, skip what's covered, and tell us what's on your truck. We fill in the rest from our records for your truck, and you check every number on your drawing before we build.
Frontier and Summit with a tonneau cover
- Open the cover all the way: roll it up, fold it toward the cab, or slide it into its canister.
- Measure A, B, C, F, G and H as shown above.
- If the cover's rails or front seal sit on top of the bed rails or the bulkhead, measure the part you can see, or skip D and E and tell us.
- Retractable cover: measure A from the bulkhead if you can reach it. If the canister is in the way, measure from the canister and tell us.
Frontier and Summit with a cap or canopy
- A: from inside the bed, at the height of the bed rails, from the front wall to the inside of the closed tailgate. Open the rear door or window to reach in.
- B and C: from inside the bed, straight across between the inside edges of the bed rails, just under the cap. B at the front, C at the back.
- F: lower the tailgate and measure how thick it is at the top edge.
- G: from outside, with the truck on level ground. Measure from the ground to the highest point of the cab, then from the ground to the top of the bed side at the front corner. Send us both numbers.
- D, E and H are under the cap. Skip them.
Apex with a cap or cover
- B, C, D, F and G are inside the bed, so they work the same with a cap or cover on.
- A (cab height): from outside, the same way as G above. Send us both numbers.
- E (outside width): measure across the outside of the bed sides, just under the cap or cover.
Let us know. Another truck of the same make, model and bed length usually works, like a friend's truck or one on a dealer lot, and we'll tell you which model years count as the same bed. Many tonneau covers also unclamp in a few minutes if you'd rather take yours off to measure.
Tell us what's on your truck (a cap or a tonneau cover, and the brand if you know it) and which letters you skipped. A few photos of the bed help too.
Not sure how to take one?
Email photos of your truck bed to sales@cascadiaoverland.com, or use our contact page, and we’ll walk you through it.